CCR1000 and CCR2000
The Only True ESD Safe Way to Remove Conformal Coatings!

CCRCo set a new standard for performance with the CCR1000 and CCR2000. Both units are fully, self-contained, non-chemical bench top workstations designed for the removal of Acrylic, Epoxy, Parylene, Silicone, or Urethane coatings from printed circuit boards and other electronic devices. Either unit may be used to strip a single component–or an entire board.

 Both the CCR1000 and CCR2000  are ESD safe and chemical free, with a sealed work chamber with gloved entry to prevent media from escaping into the atmosphere. The design and operation of each unit is exactly the same, except for two additional features in the CCR2000:

1. The ability to measure ESD voltage being applied to the printed circuit board during conformal coating removal.
2.A continuous ground monitoring system that checks: a. that the workstations is tied to your house ground, and b. that the operator is connected to the workstation.

The CCR1000 and CCR2000 workstations are environmentally safe because you don't use chemicals in conformal coating removal. They are less expensive to operate over the life of the equipment because the media used is recyclable.

No other system comes even close to the CCR1000 and CCR2000  for quick, efficient, and safe conformal coating removal. Discover what our many satisfied customers have known for years:

When it comes to Conformal Coating Removal Systems, CCRCo is the intelligent choice! Contact us today and begin to simplify your conformal coating removal process.
 

 | Home | Workstations | Eliminating ESD | Cutting Media | General Info | Removal Services |
| Reply Form | Downloads | 

 Now on GSA  

12771 Western Ave., Suite K
 Garden Grove, CA 92841-4022

Toll Free 800-443-2726
 Phone 714-901-2800
 Fax 714-901-2807
 Email info@CCRCo.com